Love pacifier advanced - anal toy by Cal Exotics - review by Katsmeow

I know the seam is a bother for some people who have this, so I was trying to think of a way to fix it. Sanding it, even if you sand it with a very fine grit, would leave scratches, which could gather bacteria... So I'm stumped. Maybe melting it slightly at the seam and smoothing it down while still hot? I'm not sure how silicone reacts to that.

I guess you could also take a straight edge razor to it and shave it off.

If anyone else has suggestions, that would be awesome :)

If it's pure silicone it will not melt with fire.

Ah the dreaded seam. :@



I always start by trying to grab it and pull it off depending on how big it is. My Ridge Rider had a bunch around the ridges that easily pulled right off.



The only thing I have found to work is a brand new razor blade (Scalpel is better) and a careful hand. Problem is it is to easy to cut into the rest of the toy. The seam will try and fold over requiring more pressure. Once it does start to cut, you have gone to far. :(



If you have a Dremel with a small sanding attachment that may work a bit better than sandpaper. But like you say it will leave scratches that could be worse than the seam. Thankfully silicone is non porous throughout so you would just need to make sure to clean those areas good. A old toothbrush works great.



Fire from a lighter typically will not melt it. Even if it did it may leave it hard and probably rough.



You really have to decide if the seam is a bother or if you can live with it. In the case of the Pacifier, I can not feel it during use so I left it alone.