This toy was definitely designed
I’ve used a few cock rings, and even when they didn’t end so well, I still enjoyed the fact that my partner’s erection was harder and he lasted longer. We looked into getting a simple cock ring, just to see how well it worked for us. This simply
rubber o-ring can be used as a
cock ring or as a
harness o-ring. With the low cost on this, I figured there wasn’t really much to loose if it didn’t work out.
The package it is contained in calls it small and on the ring is printed the size 1 ¼”. We had hoped to use this traditionally (around the penis and testicles) but the size prevented this. I should have measured him first!! :) So once he was erect, I very carefully stretched it and slid it gently down his shaft. It surprisingly stretched very well. It fit and he didn’t have any discomfort.
With all cock rings, you should not wear them for longer than twenty minutes, and if anything besides your normal erection occurs, you should promptly remove it. It was very snug on him, but not uncomfortable. If you would have pubic hair, I’d imagine it would pull. Also make sure to get placement right the first time, because it’s very difficult to move on an erect penis.
It did improve his erection and helped the sex last longer at a faster pace. He was on top but because he couldn’t (and we weren’t going to try) get it around his testicles, the bottom of the ring continually hit against my vagina which started to become almost painful after a few minutes. The stretchy rubber makes it ideal for beginners. To clean it I simply use a toy cleaner and hot water.
Overall, this o ring is simply too small for us to use it as a cock ring. I am planning on getting a harness, and will end up using it for that. If you or your partner’s penis is on the smaller side, this may work for you, but was simply too small for us.
I've seen quite a few on this site, thank you for the recommendation of those!
And for harness use, get a set/
Oggins- I know what you mean about $4. That's 35 miles in my car!! :)
Bulma- Yeah, we ordered this not really having any idea about sizes. Now that we have a clue, we'll probably invest in a better one that actually fits! :)
Jimbo Jones- I can't wait to get a harness. I'll probably order a wider variety of o-rings at the same time.
Thanks to all for your comments!
That is pretty small to be used as a cock ring in the traditional sense. My first thought was that it would work with an o-ring harness as well, but Oggins beat me to it. I purchased a few o-rings for use with our harness after getting it so that we could use it with lots of different sized dildos. It's definitely worth having some around.
1 1/4 inch would definitely not fit the traditional way (unless the idea was to "rubber" him. Ohh, what a scary thought). My husband is pretty average in size, and he takes a 2 inch ring. Good review :)
I know it was only $4, but, I can be a tightwad at times! =P
Oggins- The harness should be compatible with this, when I get around to ordering it. And it was only $4!
MaxD- Size does matter with cock rings!! :)
Haha! I guess your right Max! At least you can use this with your harness so, it's not a total bust!
Ah......see! Size really does matter! =P Great review!