Silk touch egg vibe review by Topco

Before the first use it is always wise to clean the device. The egg vibe is easy to clean for a number of reasons:

1. It has a silky touch to it. I believe that the vibrator is covered with a layer of silicone. Which gives it a silk like touch. The silicone is similar to silicone cooking tools - whatever they come in touch with does not stick very much to them. And therefore the same is true for this device.

2. You can [and definitely should] unplug the cord that attaches it to the controls/battery pack. This is easy to accomplish, since the cord connector is like a headphone connector jack. There is also no gap where the cord goes into the device, making sure its electronics won't come in touch with liquids that could otherwise damage it.

3. It takes only a couple of seconds to clean it with soap and water (ideally continuous cleaning it with your soupy hands for at least 30 seconds should remove any bacteria).

The reason for having these different pulse types is to experience different rhythms of sensations, similar to real life during intercourse, where the penis stimulates the vagina in various rhythms. After all, different people have different preferences when it comes to sexual intercourse - how fast they want to reach an orgasm, and the levels of stimulation before, while and after the orgasm takes place. Next, there is also a pulse speed or intensity setting, which when set, applies to all the pulse types unless changed individually and repeatedly for each one. The different rhythms are set by the push of a large chrome style button that is easy to push and has a good audible and physical feedback. The pulse types are reached in sequence. That means if you want to select a specific rhythm, you might have to go through all of the other ones (for example, if it is the one before one you have currently selected, as you can't go "back" by one pulse type, instead just only select one after another and then start over). This is a major downside to the controller of this vibrator. I also experienced from time to time that sometimes a pulse setting is skipped when pressing the button - perhaps my controller's button is a bit sensitive and it has not been a major issue for me. To change the pulse speed or intensity setting, the controller has a little "wheel" that is attached vertically and goes half way into the controller - just like a mouse wheel. I like that feature a lot, from an ergonomic point of view but also that it provides the possibility to fine-tune each rhythm. The downside though is that this speed or intensity setting is not stored for each rhythm, which would have been a nice feature. There are 6 small red lights underneath the button - the number of red lights turned on represents the number of the pulse type currently active. After the 6th pulse type, the device - and all its lights - turns off.

When, I am in the middle of masturbating with the Silk touch egg vibe I don't have to pull the vibrator out to change the settings.