Alpha set Automatic penis pump

Who would have the most fun with the Alpha Set?
This automatic penis pump set could be a very good idea if you:
- want quick fullness and sensitivity before sex or masturbation
- enjoy tight, realistic stroker sensations
- want two sex toys in one
- prefer automatic suction without pumping by hand

How do I use this automatic penis pump set?
1. Charge Alpha Set fully before use.
2. Fit the plain silicone seal onto the clear chamber.
3. Apply a small amount of EdenFantasys water-based lubricant around the seal and the base of your penis.
4. Slide your soft or partly erect penis into the chamber.
5. Press the seal evenly against your pubic area.
6. Turn on the automatic penis pump and begin with the lowest speed.
7. Try the gentlest pattern first and let the pressure build slowly.
8. Stop when your shaft feels warm, full, and pleasantly heavy.
9. Hold the pressure-release button until the vacuum disappears.
10. Pull the chamber off yourself gently.

How do I use the realistic pussy sleeve?
1. Fit the realistic TPR sleeve securely inside the clear chamber.
2. Add plenty of EdenFantasys water-based lubricant inside the sleeve and over your penis.
3. Guide your soft, partly erect, or erect penis into the opening slowly.
4. Turn on the pump at the lowest speed.
5. Let the vacuum pull the sleeve more closely around your shaft.
6. Try the different patterns until the sucking rhythm feels right.
7. Hold the release button before pulling out.
8. Remove and wash the sleeve immediately after use.

How does the realistic sleeve feel?
The TPR sleeve feels soft and squishy on the outside but very tight around the shaft.
As the vacuum builds, the canal draws inward and hugs more firmly, creating a sensation closer to a hard blowjob or tight penetration than ordinary open-chamber pumping.
The realistic entrance stretches visibly as it takes you, while the internal pressure can make the head and frenulum feel especially worked over.
Because the fit is snug, it is best suited to girths under about 4.71 inches.

When should I use the plain silicone seal?
When you want to focus on fullness, firmness, and sensitivity without the extra friction of a stroker sleeve.
It gives your shaft more room to expand and fits girths up to about 6.28 inches.
This setup also makes it easier to watch the vacuum change your size through the clear chamber and compare your progress against the ruler markings.

Will the Alpha Set fit my penis?
With the plain silicone seal, this penis pump fits penises up to 7 1/2 inches long and about 6.28 inches in girth.
With the realistic pussy sleeve, it fits penises up to 5 1/2 inches long and about 4.71 inches in girth.

Can I use the realistic sleeve on its own?
Yes. You can remove the TPR pussy sleeve from the Alpha Set and use it as a simple handheld masturbator.
Add plenty of EdenFantasys water-based lubricant inside the canal and over your penis, then squeeze the sleeve from the outside to change the tightness as you stroke.
Without the pump, you will not get the automatic vacuum or sucking patterns, but you will still get the sleeve's tight, realistic penetration feel.
Because the sleeve fits up to about 4.71 inches in girth, start slowly and use generous lube.

Can I use this penis pump before sex or masturbation?
Of course you can.
For partnered sex, use the automatic penis pump with the plain seal when you want your erection to look fuller and feel more responsive before oral or penetration.
For solo play, go with the plain seal first for a temporary pump-up, then switch to the realistic sleeve while your shaft is already fuller and more sensitive.
Or skip straight to the pussy sleeve and let the automatic suction do the stroking while your hands explore somewhere else.

Can this pump make my penis permanently larger?
Alpha Set can make your penis look and feel temporarily fuller and firmer by drawing more blood into the shaft.
Regular use is not likely to create substantial permanent growth.
The clear chamber and ruler markings are best used to track temporary changes during each session, not as proof of long-term enlargement.

How long should I pump for?
Begin with around 5 to 10 minutes.
Release the vacuum every few minutes and check that your penis stays warm, comfortable, and normally colored.
Stop immediately if you notice pain, numbness, coldness, strong bruising, unusual discoloration, or sharp pressure.
Do not exceed about 15 to 20 minutes in one session.

How do I make the seal stronger?
A little water-based lubricant around the base usually helps the silicone ring or realistic sleeve sit more snugly against your body.
Also check that:
- no pubic hair is trapped underneath
- the seal sits flat against your skin
- the chamber holds evenly
- you begin on the lowest speed
- you have not used so much lubricant that everything slides

How do I stop the suction?
Hold the pressure-release button until air returns to the chamber.
You will feel the pull loosen, and the sleeve or seal should release naturally. Keep holding until the vacuum is completely gone before removing your penis.

Which lubricant should I use with this penis pump set?
Use EdenFantasys water-based lubricant with both sleeves.
Add a light layer around the silicone seal for a stronger vacuum.
Use a more generous amount inside the TPR pussy sleeve so the tight canal glides instead of dragging.
Water-based lube is compatible with the silicone and TPR parts and washes away more easily after play.

How do I charge the Alpha Set?
1. Make sure the motor and charging area are completely dry.
2. Connect the USB charging cable securely.
3. Plug the cable into a suitable power source.
4. Let your penis pump charge fully.
5. Disconnect the cable before turning on or cleaning the pump.

How do I clean this automatic penis pump set?
1. Turn Alpha Set off and disconnect the charging cable.
2. Remove the sleeve or silicone seal from the chamber.
3. Separate the clear cylinder from the motor unit.
4. Wash the chamber and silicone seal with warm water, mild soap, or EdenFantasys toy cleaner.
5. Turn the TPR sleeve carefully and rinse the canal thoroughly.
6. Wash the realistic sleeve with warm water and mild soap or toy cleaner.
7. Wipe the motor and charging area with a damp cloth instead of soaking them.
8. Let every part air dry completely.
9. Reassemble the pump only when all pieces are fully dry.

How should I store the Alpha Penis Pump Set?
1. Store your Alpha Set clean, completely dry, and disconnected from the charger.
2. Keep the realistic TPR sleeve separate from the silicone seal.
3. Store both sleeves away from other soft toys that could affect their surfaces.
4. Protect the clear chamber from scratches and heavy pressure.
5. Keep the motor, chamber, and sleeves together in a pouch, box, or private drawer.
6. Store the set away from direct sunlight, heat, lint, and sharp objects.