Performance Penis pump

Who would enjoy the Performance penis pump?
This beginner penis pump could be a very good idea if you:
- want a quick, temporary size and sensitivity boost before sex or masturbation
- prefer a piston-style pump over a squeeze bulb
- need a simple beginner-friendly setup with no batteries or confusing controls

How does this piston penis pump work?
Performance creates a vacuum around your penis.
Each movement of the piston handle removes a little air from the cylinder, drawing more blood into your shaft.
As the pressure builds, your penis can become temporarily fuller, firmer, and more sensitive.
The effect lasts for a short time, which makes this penis pump make the most sense right before masturbation, oral, or partnered sex.

How do I use Performance penis pump?
1. Apply a little EdenFantasys water-based lubricant around the silicone sleeve and the base of your penis.
2. Slide your soft or partly erect penis into the clear cylinder.
3. Press the silicone rim firmly against your pubic bone to create a seal.
4. Work the piston slowly, one controlled stroke at a time.
5. Pause after each movement and let the pressure settle.
6. Stop when your shaft feels pleasantly full and throbbing.
7. Press the safety release valve before removing the cylinder.

What makes the piston handle special?
The piston-style control gives you a longer, firmer pumping motion than a hand bulb.
That makes it easier to build pressure in deliberate steps and feel exactly how your body responds after each stroke.
The large handle also gives your hand more leverage, which can feel more natural if you dislike repeatedly squeezing a bulb.

What does penis pumping feel like?
At first, it feels like a gentle tug around your penis.
As the vacuum grows, that tug becomes a heavier, tighter pressure.
Your shaft may feel warmer, fuller, and much more present in your hand.
The head can become more sensitive too, which is exactly why Performance works so well as a warm-up before stroking or sex.
The pressure should feel exciting and controlled, never sharp, numb, cold, or painful.

Can I use this penis pump before sex?
For sure!
Use Performance as a pre-sex warm-up when you want your erection to feel fuller, firmer, and more sensitive.
Pump slowly, release the pressure, remove the cylinder, and move into stroking, oral, or penetration while your shaft still feels extra responsive.

Can I use it before masturbation?
Yes, and it can make an ordinary mastur-session feel much more interesting.
Pump until your penis feels comfortably full, release the vacuum, and begin stroking while your shaft is still warm and sensitive.
The extra blood flow can make every pass of your hand or your stroker feel stronger, especially around the head and frenulum.
You can also edge first, pump second, then return to stroking when you want the finish to feel heavier and more full-body.

Can this penis pump improve my erection?
The vacuum Performance creates around your penis temporarily draw more blood into the shaft, helping it look and feel firmer during and shortly after pumping.
Results vary, and Performance is not a medical device or a treatment for erectile dysfunction.
If erection problems happen often, appear suddenly, or cause concern, speak with a qualified healthcare professional.

How long should I pump?
Start with around 5 to 10 minutes.
Release the pressure every few minutes and check how your penis looks and feels.
Your shaft should stay warm, comfortable, and normally colored.
Stop immediately if you notice:
- pain
- numbness
- coldness
- discoloration
- bruising
- sharp pressure
Do not exceed about 15 to 20 minutes in one session unless a healthcare professional has advised you differently.

Will my penis fit inside Performance?
The usable chamber measures 8 inches long with up to 2 inches of internal diameter when the silicone sleeve is in place.
That equals about 6.28 inches in circumference, though a little extra room is better for expansion.
The silicone opening stretches from around 3/4 inch to 2 inches in diameter, helping it seal around a range of shaft sizes.
Measure your erect length and widest girth before use. You want enough space to grow without pressing hard against the top or sides of the cylinder.


How do I get a better seal?
A small amount of water-based lubricant around the silicone rim usually makes the biggest difference.
Also make sure:
- pubic hair is not trapped under the sleeve
- the rim sits flat against your body
- the cylinder is pressed evenly into place
- the first few piston strokes are slow
- you are not using so much lube that everything slides around

Should I use a cock ring after pumping?
A properly sized cock ring can help maintain the fuller look for a little longer after pumping.
Do not use one that feels painfully tight, and remove it immediately if you notice pain, numbness, coldness, or dark discoloration.
Avoid combining very strong pumping with an extremely tight ring.

Can my partner use Performance on me?
Absolutely.
A partner can hold the cylinder in place, work the piston slowly, and watch your shaft become fuller while you tell them when to pause or release.
That turns pumping into foreplay instead of something you do before the fun starts.

What lubricant should I use?
EdenFantasys water-based lubricant is always a good idea - it's 100% body-safe and toy-compatible.
Apply a small amount around the silicone sleeve and the base of your penis.
This helps the rim sit comfortably and creates a stronger seal.
Do not flood the area. Too much lubricant can make the pump slide around just when the pressure starts feeling good.

Who should avoid using a penis pump?
Speak with a healthcare professional before using Performance if you:
- take blood-thinning medication
- have a bleeding disorder
- have reduced genital sensation
- have a history of blood clots
- bruise very easily
- have been told to avoid devices that affect circulation

How do I release the pressure safely?
Press the safety release valve and wait for air to return to the cylinder.
You will feel the tight pull loosen, and the pump should lift away easily.
Do not yank the cylinder off while the vacuum is active unless you want the ending to become much more dramatic than necessary.

How do I clean this penis pump?
1. Take apart the cylinder, silicone sleeve, hose, piston handle, and removable pieces.
2. Wash the cylinder and silicone parts with warm water, mild soap, or EdenFantasys toy cleaner.
3. Wipe the hose and piston assembly carefully instead of filling them with water.
4. Rinse the washable parts well.
5. Let everything air dry completely.
6. Put Performance back together only when every part is dry.
7. Keep water out of the hose and piston mechanism so the pump stays ready for the next round.

How should I store this penis pump?
1. Store Performance clean, dry, and either loosely assembled or taken apart.
2. Keep the hose from folding sharply, and do not crush the silicone sleeve under anything heavy.
3. Protect the clear cylinder from scratches in a pouch, drawer, or storage box.
4. Store all the parts together so the piston handle does not decide to disappear before your next session.