*Charging
Noa does not recharge with a magnetic charger. Rather, it has a small port that a plug is inserted into. Simply unscrew the two pieces at the silver band, and the charging port will be exposed on the external portion of the toy. This plug-in port makes charging it much easier, and there are no worries about it coming loose during charging, or getting a bad connection. It connects to its charger securely every time. Noa cannot be used while charging.
Noa comes with a 13” USB cable for charging. It is also compatible with other Lelo chargers, so it can be charged through either the USB cable, or any other Lelo plug-in charger you have already. This makes Noa very easy to power up, and makes traveling with it that much easier. When charging, Noa’s light blinks, and then shines steady when fully charged.
Upon arrival, Noa’s first charge to get it at full power took about 30 minutes. It ran off that charge on full-speed, steady vibration for about 45 minutes. The next charge (a recharge after being completely dead) took about 1.5 hours. Noa ran on full-speed, steady vibration for about 50 minutes off that recharge. It began losing just a little power after about 30 or 40 minutes, and warmed up just a tiny bit. Neither change was noticeable or enough to become uncomfortable. Its light flashes faster and faster as the battery’s power gets lower and lower.
*Functions/Controls
Already have one of Lelo’s Sense Motion toys with a remote? Noa is compatible with that remote, and by using the remote with your Noa you will be able to access more power levels, and more pattern options. Noa’s 1 control button is right above the silver, plastic band. To turn the Noa on and make it receptive to your Sense Motion remote, push the button once briefly. Noa will flash slowly, but will not vibrate. Then use your remote to adjust Noa’s power level and setting. The Sense Motion technology works with it too.
To use Noa alone without the remote, once it is flashing, simply push the same button again briefly. The toy will continue to flash and will also start vibrating. It will turn on in steady vibration mode. To cycle through the 5 other settings, push the same button briefly. Noa only cycles up by itself, so if you miss the setting you want, cycle through all the settings and start over again. When the toy is turned off, it will start up at the first, steady vibration setting the next time it’s turned on. To turn Noa off, push and hold the button for about 3 seconds, or until the toy stops vibrating and flashing. Noa cannot be locked for travel, but it is unlikely that the button would accidentally get pushed during storage.
Alone, without the Sense Motion remote, Noa has 6 total settings. To standardize my vroom and bee rating I always use the
Je Joue MiMi. Noa’s vibrations are midway between rumbly and buzzy, they are nearly identical to MiMi’s vibrations. The settings are as follows:
1.Steady vibration – 2 vrooms, 2 bees – comparable to MiMi on level 2
2.Slow pulsing – 3 pulses per second
3.Faster pulsing – 4 pulses per second
4.Roller coaster up/escalating fast – 1 cycle in 1.5 seconds
5.Roller coaster up/escalating slower – 1 cycle in 3 minutes
6.Random pluses of differing strengths and lengths
When used with a Sense Motion remote, Noa has more power settings. Not only can the steady vibration mode be changed, but the power level of each patterned setting can also be changed. With a Sense Motion remote, Noa’s power settings are as follows:
1.High – 3 vrooms, 2 bees – comparable to MiMi on level 3
2.High medium – 2.5 vrooms, 2 bees – comparable to MiMi between levels 2 and 3
3.Medium – 2 vrooms, 2 bees – comparable to MiMi on level 2
4.Low medium – 1.5 vrooms, 2 bees – comparable to MiMi between levels 1 and 2
5.High low – 1 vroom, 2 bees – comparable to MiMi on level 1
6.Low – 0.5 vrooms, 1 bee – comparable to MiMi below level 1
In the hand, the vibrations seem to travel well from the external part to the internal part of Noa. In use, however, the vibrations really are not felt internally.
@ Supervixen - This was my first time ever trying one of the vibes you wear during sex, so I did have a bit of a learning curve when I first tried to use it. It's pretty intuitive though. I can't really compare it myself, but I have read the reviews on the Tiani 2 (also by Lelo) and it sounds like it is quite a bit stronger, more in line with the strength of the Lyla 2. I am not familiar with the We-Vibes, so I can't comment on those.
Yes, your male partner will more than likely feel the internal portion of this toy. It is concave though, to hopefully make it more comfortable - whether or not that is a problem will depend on your male partner's preferences. There are no vibrations on the internal portion, so your male partner will not get any additional stimulation from that.
I hope that helps.