I know it would take insane precision to get the hole and tubing to pass through that huge shaft, but I think it would be nice when I pull it out at the stall for it to really come out.
Does anyone think this could be used as an STP?
03/29/2012
- 1
- 2
- 3
- 4
- 5
Quote:
I believe there are videos on Youtube that display how to turn a packer into an STP. The only real issue I can see is how difficult it would be to bore through it without puncturing the side by screwing up the angle.
Originally posted by
Wawers
I know it would take insane precision to get the hole and tubing to pass through that huge shaft, but I think it would be nice when I pull it out at the stall for it to really come out.
03/29/2012
It is much much better to just buy an STP. The Peecock company is located in Singapore and so it can be a little costly to order from over there but it is completely silicone, very lifelike, no risk of "messing up" like when you do it yourself and could ruin the product, and the larg-ish funnel at the top prevents spill over which can be an issue with some other designs
04/13/2012
It can be used, and there are tons of was to do it. But I agree with Exquisite: it may be better to save up for a pre-made STP.
04/15/2012
I have heard the material really picks up a lot of fibers and the like, which wouldn't be good for an stp
04/15/2012
Not good for STP
04/16/2012
Quote:
Yes it is very possible to turn it into an STP. There are youtube videos that show how to do it step by step. You would have to be very careful but if you can make it work I would say go for it!
Originally posted by
Wawers
I know it would take insane precision to get the hole and tubing to pass through that huge shaft, but I think it would be nice when I pull it out at the stall for it to really come out.
04/25/2012
material is too unsafe for STP
04/26/2012
Quote:
Many people do create their own STPs with these, but if you're using heat to create a hole, I hear it melts real fast! Also, I'm not sure why someone said they're unsafe considering most of the "professionally made" STPs use this product.
Originally posted by
Wawers
I know it would take insane precision to get the hole and tubing to pass through that huge shaft, but I think it would be nice when I pull it out at the stall for it to really come out.
04/27/2012
It's certainly possible, but I wouldn't recommend it. It seems like it'd be a bit unwieldly, which could mean lots of accidents.
06/14/2012
I would just use a basic limpy to make an STP. no one is gonna look at your dick in the restroom
07/28/2012
Quote:
the 5 incher is probably best for an stp. You'd have no problem pulling that one out even though they call it "small"
Originally posted by
Wawers
I know it would take insane precision to get the hole and tubing to pass through that huge shaft, but I think it would be nice when I pull it out at the stall for it to really come out.
11/19/2012
Total posts: 12
Unique posters: 12