A tight squeeze

The Zpang easy fit is your typical masturbator for men. Lube it up and stick your cock in and thrust or secure creatively and go at it hands-free. It's best use is solo, but couples could enjoy it as well. It has no electronics or moving parts, so it is water-proof if you like to play in the shower or tub. It's recommended to use water-based lubes only. They even included a sample lube.

If you are looking for a tight sleeve to jack off with that is easy to care for this might be it.

The outer case is a hard plastic shell. Not real thick or too thin. The inner liner sleeve is sorta like a TPR...a mix of silicone and elastomer. This rates a 7 on the EF safety scale. The material is sorta firm. Definitely firmer than a Fleshlight. The orifice is not specific. Just a generic round hole that is not textured. Once deeper inside there are little textured fingers to stimulate the head of the penis. This is aimed more towards beginners. In use, I really didn't notice much texture. It was rather tight and felt more or less smooth.

There is no distinct smell. You need to use plenty of lube to get your cock inserted, because it is so tight. It also kinda squeegees the lube off your penis as you thrust, so you have to reapply or refresh with saliva to keep it slick. It's a little tighter than I prefer, but gets the job done still. There is not a lot of give to the opening compared to cyberskin or flesh-like materials.

I was quite surprised how small these were when I opened the package from EF. I expected something closer to a Fleshlight, but they are pretty small. About 6" tall and 3" wide. Less than half the size of a Fleshlight, both shorter and narrower. I guess that makes them travel-friendly, but not exactly discreet either. They would not take up much room in a checked bag though if you needed some travel pussy.

Considering it's only 6", you won't be doing much deep thrusting if you have a long cock. The shape is like a lunar module and makes for an easy grip for stroking, as the base flares wider at the entrance. The end part does twist and extend about an extra inch. I'm not sure if this is to accommodate size or to adjust suction (or both?). The internal sleeve, is a closed structure and the insertion end extends outward past the lip of the sleeve. It moves out when you pull out and goes back in when thrusting, unless you use enough lube.. It is pretty tight and creates quite a bit of suction. This should accommodate small to medium thick penises.

I found this to be a bit tighter than I would like. I am about 5 1/4"-5 1/2" circumference and it was very tight with lots of suction. When using Fleshlights, I tend to go for one that are looser. Not death-grip tight. They do offer an even tighter version, which I imagine would be too tight for me, personally. My dick would probably get sore if I used it for a long session.

Pulling the inside out.


Free lube sample

The upper end twists and extends the shell and inner sleeve about an extra inch. I didn't really notice much difference though. I wasn't really using this for deep penetration either. It is reasonably quiet and provides a tight fit with a lot of suction (or at least feels like it, because it is so tight). It is waterproof. Overall, it is easy to use and reasonably stimulating. Not as good as a Fleshlight for basis of comparison, but good enough to get off with.

Care is simple. Just wash with warm soap and water and/or toy cleaner. be sure to let it dry before storing the sleeve back in the case, so you don't grow mold or any nasty smells. This can easily be stored in a drawer or toy chest.

You can not run water all the way through it, so you can just run water into the opening and swirl around with your finger to clean it and then pour it out and let it dry.

There was no packaging. The top was shrink wrapped, but the bottom was not. I also go the tight version for assignment and it was shrink wrapped on both ends, but there is no packaging to speak of; just a plastic wrapping with a little info on it. A water-based lube sample is included (underneath the end cap).

This is a picture of the slim fit version to show what the "packaging" is like.