As my first Outlaw Leather harness (regular one, anyway), I went bad ass with the Annie-O. It's a really sexy harness with black leather, metal accents, and a lace up corset backing. If you can afford it (and it's worth it!) it will be a great choice for a beginner or an expert. It also fits a HUGE range of sizes! I wear a size 8 (in almost all American Eagle jeans if you need a comparison), and I have a lot of left over room in the straps! This harness will easily fit plus sizes. It's comfortable enough and sturdy. It's not best for all positions because of the amount of metal hardware, but for a dominant pegger, you'll find plenty of positions to use this in. It comes with a large metal o-ring and a replacement also large rubber one. Become Annie-O, gunslinger of dildos!

This Annie-O harness is made of real leather that comes in black or brown (currently on Eden it is only in black). I have the black one which has a red back corset panel. The leather does smell like wonderful real leather. I don't think as vegetarian I should like that smell (tisk tisk, I know!). The leather is very soft and also flexible. It has two sides. The outward side is smoother with no texture and has a slight matte feel to it. The other side is textured and slightly fuzzy ans worn. It feels great against the skin. The leather is about 1/8" thick and is very strong. It doesn't have any stretch to it when you get the harness. The metal hardware on this harness is made of nickle platted steel. There are also nylon cords. The red pice in the back is made of red dyed leather and has both sides that are fuzzy.

The this harness has a double strapped design, so instead of fitting like a thong, it is more like a brief with a strap going around each leg and over the butt cheeks. Once you have all the straps adjusted to your size, it s very easy to slip on and off and then tighten accordingly. The design works well for many hips sizes, but may be uncomfortable for those with a droopy tummy since this does hide VERY low. An "over hang"could cut in and be uncomfortable. If you have a juicy butt or hips, have no fear! This harness can be adjusted to fit both. The side of the harness are adjustable and so are the straps that go between the legs and up the butt connecting in the back of the harness. Even the corset panel in the back is adjustable! I don't mess with this, though. It's hard to adjust.



The side/hips straps are like belts. They are 7/8" wide. The extra slack can be looped through the area right behind the buckle which is also where the butt straps connect. If you are really small, these buckles will be placed closer the the front, if you are plus size, they will be positioned more towards the back. For me that are a little behind my side. The butt straps are adjusted with the use of two D buckles and are 5/8" wide. The corset part is adjusted by the use of a cord. This can make the hip buckles move more toward the front if you let out slack in the corset.

The part where the pantie portion would be is double with leather pieces so that the dildo put into it is secure. There is a lot of metal hardware on this middle piece. Each strap is secured into the leather with two rivets. The center hole is actually more of a tear drop shape that accommodates more than just perfectly circular dildos. There is also a noticeable gap between the tow pieces of leather so it can accommodate balls too. Honestly, it might be possible for a guy to wear this harness, although I didn't have my boyfriend try it out, I think it would look really hot if it were able to fit!



The pantie part is 6 1/2" wide at the largest part. From the center of the top to the bottom, it is 5 1/2" long. The hole in the center is 1 1/4" wide and 2 3/8" long. If you don't have the dildo go through that hole which the second layer, the first hole is completely round and 1 7/8" across. This accommodates the majority of strap on dildos, flared base required.



Both o-ring have the same inner diameter of 1 7/8". The o-rings snap in place at three points. you can of course use your own o-ring but using one with an inner diameter smaller than about 1/2" will cause the middle to buckle in on itself. It will fit many toys from medium to large sized. It will fit hard dildos of 1 1/2" in diameter to about 2 1/8" in diameter of a a softer material.

The best way to put the harness on is to step into it and adjust the hips first. You'll need to go form side to side tightening it so it doesn't end up lopsided. Then you can adjust the butt straps to assure a tight and secure fit.




The minimum hip measurement is 28 inches. This is without adding your own holes to the harness. If you are even tinier than that, there are a few more inches to play with on your own. The maximum is an astounding 62" in hip circumference That means this will fit up to a size 5X (according to conversion charts I found). So this will fit 00 to well into plus sizes. This harness is designed to be catered to you and the straps should be cut with a few inches of slack when you have figured out your size.

To use after fitting yourself into the harness, you can slide a dildo in. It's easiest to do from the side since the top opening is smaller. If you need to exchange the o-ring for a difference one, unsnap the three snaps in the center portion. Add the dildo by sliding it through and place it between the two layer of leather, or place the flared portion behind both. It's up to you and your personal preferences. The harness will lay more flat if you put the dildo between instead of behind both. It will fit toys that have balls as long as they aren't huge.
You don't have to worry about heavy toys because this harness already rides really low. It might cause the harness to dig deeper into the hips but it won't compromise the security of the harness. During use, the harness is extremely comfortable unless you are laying up against the hip procurements in the back. They can dig in over time or with rough movements.

Remove any toys and the detachable rings, before washing your harness. According to the Outlaw FAQ, you can rinse the harness under warm water and a small amount of anti-bacterial soap. Do not use anything abrasive to scrub it or wipe it.

Use a hairdryer set on cool to dry it, then you can hang it for 4-6 hours. Make sure to unsnap everything so it does not rust. A hairdryer is preferred, but if you do not have one use a soft cloth to dry it before hanging.

For maintenance of the leather they recommend using a protectant for all parts of the harness. Apparently lotions can be used too. If it is good for your skin, it is good for leather, just be sure it has no harsh chemicals or aromas. Since leather is not a material that can be sterilized, Outlaw recommends using a different harness for different partners.

Wetting leather makes me nervous even if these instruction are coming from the company. I prefer to spot clean mine with a damp soft cloth and no soap. It has worked fine so far.

You need to store your harness in a cool and dry place so the leather does not get ruined.

My harness came in a very nice velvet bag with a draw string. There isn't much other than that in terms of packaging. There is a small chain that attaches the second o-ring and small tag to the metal o-ring. I would keep the bag because the leather easily scuffs as you can see in some of my pictures. I only wore it once and it ended up looking like that.

For some reason my harness didn't come with the star that is shown on the front. I'm very sad about that!

This harness does ride low enough that it can be used with a double dildo! The tag also shows that two dildos can be placed in the harness back to back to create a tailored double dildo.